Hyundai Veloster Owners Manual
Headlight, position light, turn signal light, front fog light bulb replacementMaintenance / Light bulbs / Headlight, position light, turn signal light, front fog light bulb replacement
(1) Headlight (Low)
(2) Headlight (High)
(3) Front turn signal light
(4) Position/DRL light
(5) Front fog light*
Headlight bulb
WARNING - Halogen bulbs
- • Halogen bulbs contain pressurized gas that will produce flying pieces of glass if broken.
- • Always handle them carefully, and avoid scratches and abrasions. If the bulbs are lit, avoid contact with liquids. Never touch the glass with bare hands. Residual oil may cause the bulb to overheat and burst when lit. A bulb should be operated only when installed in a headlight.
- • If a bulb becomes damaged or cracked, replace it immediately and carefully dispose of it.
- • Wear eye protection when changing a bulb. Allow the bulb to cool down before handling it.
✽ NOTICE
If the headlight aiming adjustment is necessary after the headlight assembly is reinstalled, consult an authorized HYUNDAI dealer.
1. Open the hood.
2. Remove the headlight bulb cover by turning it counterclockwise.
3. Disconnect the headlight bulb socketconnector.
4. Remove the bulb from the headlight assembly.
5. Install a new headlight bulb.
6. Connect the headlight bulb socket connector.
7. Install the headlight bulb cover by turning it clockwise.
Position light (if equipped)
If the light does not operate, have the vehicle checked by an authorized HYUNDAI dealer.
Turn signal light
1. Remove the socket from the assembly by turning the socket counterclockwise
until the tabs on the socket align with the slots on the assembly.
2. Remove the bulb from the socket by pressing it in and rotating it counterclockwise
until the tabs on the bulb align with the slots in the socket. Pull the bulb out
of the socket
3. Insert a new bulb by inserting it into the socket and rotating it until it locks
into place.
4. Install the socket in the assembly by aligning the tabs on the socket with the
slots in the assembly. Push the socket into the assembly and turn the socket clockwise.
Front fog light bulbs (if equipped)
1. Remove the under cover by rotating the screws.
2. Reach your hand into the back of the front bumper.
3. Disconnect the power connector from the socket.
4. Remove the bulb-socket from the housing by turning the socket counter clockwise
until the tabs on the socket align with the slots on the housing.
5. Install the new bulb-socket into the housing by aligning the tabs on the socket
with the slots in the housing. Push the socket into the housing and turn the socket
clockwise.
6. Connect the power connector to the socket.
